Differences

This shows you the differences between two versions of the page.

--- articles:as9100d_product_safety [2022/03/15 22:06] – [What should you "really" do to address "Product Safety"?] rrandall
+++ articles:as9100d_product_safety [2022/03/18 07:00] (current) – [What should you "really" do to address "Product Safety"?] rrandall
@@ Line 107: / Line 107: @@
 ===== What should you "really" do to address "Product Safety"? =====
-AS9100 is so poorly written that IAQG should be embarrassed. And the presentation from the IAQG [[https://iaqg.org/tools/scmh/|SCMH (Supply Chain Management Handbook)]] titled "SCMH-3.9.2-Product Safety Awareness Guidance" (Rev. B, Dated-29SEP2021) expands the concept to the point of being ridiculous (expanding the scope of AS9100 from Quality into safety). So let's forget about AS9100 and just focus on doing "the right thing".
+AS9100 is so poorly written that IAQG should be embarrassed. And the presentation from the [[https://iaqg.org/|IAQG (International Aerospace Quality Group)]] [[https://iaqg.org/tools/scmh/|SCMH (Supply Chain Management Handbook)]] titled "SCMH-3.9.2-Product Safety Awareness Guidance" (Rev. B, Dated-29SEP2021) inappropriately expands the scope of AS9100 from //Quality// into //Safety// (which is a word not defined by IAQG or ISO, but is defined by IEC 8000-1:2010 as: "//freedom from unacceptable risk of physical injury or damage to the health of people or damage to property or the environment//")! To make "product safety" an all-encompassing requirement requires a broader view of the term. In reality, the primary responsibility for realization of a "safe" product resides with the Design/Engineering function (8.3). The manufacturing function can only verify that they manufacture the product in accordance with the requirements set forth by the Design/Engineering function (which is the definition of "quality"... as defined by ISO 9001:2015 as the "//degree to which a set of inherent characteristics of an object fulfills requirements//"). If the design of a product is flawed (unsafe), and manufacturing produces a product that conforms with the Engineering specifications, the manufacturing function typically has no knowledge of the design defect.
 Walter Sam O’Connor, Vice President - Technical Services for the [[https://www.aviationsuppliers.org|Aviation Suppliers Association (ASA)]], provides a presentation on how to ensure "product safety" (focusing on AS9100/AS9110/AS9120):