Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision |
articles:optimizing_calibration_intervals [2020/01/14 13:01] – [Reducing Waste: Through Optimizing Calibration Intervals] rrandall | articles:optimizing_calibration_intervals [2020/01/14 13:16] – [Reducing Waste: Through Optimizing Calibration Intervals] rrandall |
---|
One company I visited, had over 13,000 instruments in their calibration system. They'd contracted all of the calibrations with a metrology laboratory that "optimized" their calibration intervals for them. The number of instruments found "Out-of-Tolerance" dropped from 5% (650 instruments) per year to less than 0.5% (only 65 instruments)! This reduced their risk (of "Out-of-Tolerance" instruments being used to inspect product), reduced their administrative costs (associated with performing "Out-of-Tolerance" impact analysis), and reduced their total annual cost for calibration services (fewer calibrations were performed)! | One company I visited, had over 13,000 instruments in their calibration system. They'd contracted all of the calibrations with a metrology laboratory that "optimized" their calibration intervals for them. The number of instruments found "Out-of-Tolerance" dropped from 5% (650 instruments) per year to less than 0.5% (only 65 instruments)! This reduced their risk (of "Out-of-Tolerance" instruments being used to inspect product), reduced their administrative costs (associated with performing "Out-of-Tolerance" impact analysis), and reduced their total annual cost for calibration services (fewer calibrations were performed)! |
| |
<note>An excellent paper on this topic is [[https://us.flukecal.com/literature/articles-and-education/electrical-calibration/papers-articles/calibration-intervals-manuf|"Calibration Intervals, A Manufacturer's Perspective"]], written by David Deaver - Fluke Corporation.</note> | <note>An excellent paper on this topic is [[https://us.flukecal.com/literature/articles-and-education/electrical-calibration/papers-articles/calibration-intervals-manuf|"Calibration Intervals, A Manufacturer's Perspective"]], written by David Deaver - [[https://us.flukecal.com|Fluke Corporation]].</note> |
===== Methodologies for the Determination of Calibration Intervals ===== | ===== Methodologies for the Determination of Calibration Intervals ===== |
| |