Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| articles:optimizing_calibration_intervals [2019/03/17 18:49] – [Optimizing Calibration Intervals] rrandall | articles:optimizing_calibration_intervals [2019/03/17 18:50] – [Reducing Waste through Optimizing Calibration Intervals] rrandall | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Reducing Waste through | + | ====== Reducing Waste: Through |
| One of the most often overlooked areas in Lean Six Sigma for reducing waste is the optimization of calibration (i.e., metrological confirmation) intervals. \\ | One of the most often overlooked areas in Lean Six Sigma for reducing waste is the optimization of calibration (i.e., metrological confirmation) intervals. \\ | ||
