Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
articles:optimizing_calibration_intervals [2019/03/17 18:49] – [Optimizing Calibration Intervals] rrandall | articles:optimizing_calibration_intervals [2019/03/19 21:36] – [Reducing Waste: Through Optimizing Calibration Intervals] rrandall | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Reducing Waste through | + | ====== Reducing Waste: Through |
One of the most often overlooked areas in Lean Six Sigma for reducing waste is the optimization of calibration (i.e., metrological confirmation) intervals. \\ | One of the most often overlooked areas in Lean Six Sigma for reducing waste is the optimization of calibration (i.e., metrological confirmation) intervals. \\ | ||
Line 8: | Line 8: | ||
If M&TE calibration intervals were optimized based upon performance, | If M&TE calibration intervals were optimized based upon performance, | ||
+ | |||
+ | One company I visited, had over 13,000 instruments in their calibration system. They'd contracted all of the calibrations with a metrology laboratory who " | ||
+ | |||
===== Methodologies for the Determination of Calibration Intervals ===== | ===== Methodologies for the Determination of Calibration Intervals ===== | ||